Fujitsu 1FINITY L100 - Page 72

Connector Descripons
Table 21
Connector and Funcon
Connector Connector Type Locaon Funcon
LCN1 SFP cage Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX opcal connecon to DCN Cloud
Note: The LCN1 port cannot be used simultaneously
with the UTLP port.
LCN2 SFP cage Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX opcal connecon to DCN Cloud
Note: The LCN2 port cannot be used simultaneously
with the UTLP port.
LCN3 SFP cage Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX opcal interblade communicaon
connecon for blades within one ROADM system
Note: The LCN3 port cannot be used as a
communicaon connecon to another blade or
device outside the virtual NE.
LCN4 SFP cage Front panel 100Base-T/1000Base-T electrical or 1000Base-SX/
LX10/EX/ZX opcal interblade communicaon
connecon for blades within one ROADM system
Note: The LCN4 port cannot be used as a
communicaon connecon to another blade or
device outside the virtual NE.
LMP RJ-45 Front panel 100Base-T/1000Base-T LMP connecon for cra
interface to WebGUI
MAINT RJ-45 Rear panel 100/1000Base-T connecon of maintenance port
UTLP RJ-45 Front panel Future use
Note: The RST push-switch is used to acvate a CPU WARM reset.
Unit Description
L110 Blade
72
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only