Value Units / Interpretation RFID Configuration Definition / Function
Pxxx where xxx: 3-Digit Value
Sets the tag encoding position:
A value of 0.00 causes the print position to be used.
A value greater than 0 causes the present position to be used.
(Subject to change.)
Rn where n: 0 – 9 Sets the number of retries for RFID functions.
Shh where hh:
2-Chararacter
Hex ID
Sets the Electronic Article Surveillance (EAS) set, representing the
manufacturer’s code (HF only).
Tn where n:
0 = ISO 15693
1 = Texas
Instruments
2 = Philips
3 = ST Micro
LRI 512
4 = ST Micro
LRI 64
Establishes the tag type (HF only).
Un where n:
0 = EPC 0
1 = EPC 0+
Matrics
2 = EPC 0+
Impinj
3 = EPC 1
6 = UCODE
EPC 1.19
7 = EM
4022/4222
8 = Gen 2
Sets the UHF tag type (Multiprotocol UHF only).
Vn where n: -4 to +4 Adjusts the power, in dBmn (Multiprotocol UHF only).
Wn where n:
E = Enable
D = Disable
Allows locking the tag after writing.
Example
<STX>KcRIMH;RIA11E;RID22E;RIS04;RIR3;RIWE;RIEE;RIP000<CR>
DPL Command Reference
115
To Next Page
Loading...
Need help?
General