Huawei Quidway S9300

[PE1] display mpls ldp session
LDP Session(s) in Public Network
------------------------------------------------------------------------------
Peer-ID Status LAM SsnRole SsnAge KA-Sent/Rcv
------------------------------------------------------------------------------
2.2.2.9:0 Operational DU Active 000:00:01 6/6
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
LAM : Label Advertisement Mode SsnAge Unit : DDD:HH:MM
[PE1] display mpls ldp lsp
LDP LSP Information
------------------------------------------------------------------------------
SN DestAddress/Mask In/OutLabel Next-Hop In/Out-Interface
------------------------------------------------------------------------------
1 1.1.1.9/32 3/NULL 127.0.0.1 Vlanif30/InLoop0
2 2.2.2.9/32 NULL/3 172.1.1.2 -------/Vlanif30
3 3.3.3.9/32 NULL/1025 172.1.1.2 -------/Vlanif30
------------------------------------------------------------------------------
TOTAL: 3 Normal LSP(s) Found.
TOTAL: - Liberal LSP(s) Found.
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
Step 3 Configure VPN instances on each PE and connect the CEs to the PEs.
# Configure PE1.
[PE1] ip vpn-instance vpna
[PE1-vpn-instance-vpna] route-distinguisher 100:1
[PE1-vpn-instance-vpna] vpn-target 111:1 both
[PE1-vpn-instance-vpna] quit
[PE1] ip vpn-instance vpnb
[PE1-vpn-instance-vpnb] route-distinguisher 100:2
[PE1-vpn-instance-vpnb] vpn-target 222:2 both
[PE1-vpn-instance-vpnb] quit
[PE1] interface vlanif 10
[PE1-Vlanif10] ip binding vpn-instance vpna
[PE1-Vlanif10] ip address 10.1.1.2 24
[PE1-Vlanif10] quit
[PE1] interface vlanif 20
[PE1-Vlanif20] ip binding vpn-instance vpnb
[PE1-Vlanif20] ip address 10.2.1.2 24
[PE1-Vlanif20] quit
# Configure PE2.
[PE2] ip vpn-instance vpna
[PE2-vpn-instance-vpna] route-distinguisher 200:1
[PE2-vpn-instance-vpna] vpn-target 111:1 both
[PE2-vpn-instance-vpna] quit
[PE2] ip vpn-instance vpnb
[PE2-vpn-instance-vpnb] route-distinguisher 200:2
[PE2-vpn-instance-vpnb] vpn-target 222:2 both
[PE2-vpn-instance-vpnb] quit
[PE2] interface vlanif 40
[PE2-Vlanif40] ip binding vpn-instance vpna
[PE2-Vlanif40] ip address 10.3.1.2 24
[PE2-Vlanif40] quit
[PE2] interface vlanif 50
[PE2-Vlanif50] ip binding vpn-instance vpnb
[PE2-Vlanif50] ip address 10.4.1.2 24
[PE2-Vlanif50] quit
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-61