Huawei Quidway S9300

[PE1] bgp 100
[PE1-bgp] ipv4-family vpn-instance vpna
[PE1-bgp-vpna] peer 10.1.1.1 as-number 65410
[PE1-bgp-vpna] import-route direct
[PE1-bgp-vpna] quit
[PE1-bgp] ipv4-family vpn-instance vpnb
[PE1-bgp-vpnb] peer 10.2.1.1 as-number 65420
[PE1-bgp-vpnb] import-route direct
[PE1-bgp-vpnb] quit
NOTE
The configuration procedure of PE2 is similar to the configuration procedure of PE1 and is not mentioned
here.
After the configuration, run the display bgp vpnv4 vpn-instance peer command on a PE, and
you can find that the BGP peer relation between the PE and CE is in Established state.
Take the peer relation between PE1 and CE1 for example:
[PE1] display bgp vpnv4 vpn-instance vpna peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1 Peers in established state : 1
Peer V AS MsgRcvd MsgSent OutQ Up/Down State
PrefRcv
118.118.118.2 4 65410 11 9 0 00:07:25 Established
1
Step 5 Set up MP-IBGP adjacency between the PEs.
# Configure PE1.
[PE1] bgp 100
[PE1-bgp] peer 3.3.3.9 as-number 100
[PE1-bgp] peer 3.3.3.9 connect-interface loopback 1
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 3.3.3.9 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure PE2.
[PE2] bgp 100
[PE2-bgp] peer 1.1.1.9 as-number 100
[PE2-bgp] peer 1.1.1.9 connect-interface loopback 1
[PE2-bgp] ipv4-family vpnv4
[PE2-bgp-af-vpnv4] peer 1.1.1.9 enable
[PE2-bgp-af-vpnv4] quit
After the configuration, run the display bgp peer or display bgp vpnv4 all peer command, and
you can see that the BGP peer relation between the PEs is in Established state.
[PE1] display bgp peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1 Peers in established state : 1
Peer V AS MsgRcvd MsgSent OutQ Up/Down State
PrefRcv
3.3.3.9 4 100 12 6 0 00:02:21 Established
0
[PE1] display bgp vpnv4 all peer
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-63