Huawei Quidway S9300

<PE1> system-view
[PE1] mpls lsr-id 1.1.1.1
[PE1] mpls
[PE1-mpls] label advertise non-null
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface vlanif 10
[PE1-Vlanif10] mpls
[PE1-Vlanif10] mpls ldp
[PE1-Vlanif10] quit
[PE1] interface vlanif 30
[PE1-Vlanif30] mpls
[PE1-Vlanif30] mpls ldp
[PE1-Vlanif30] quit
# Configure PE2.
<PE2> system-view
[PE2] mpls lsr-id 2.2.2.2
[PE2] mpls
[PE2-mpls] label advertise non-null
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface vlanif 10
[PE2-Vlanif10] mpls
[PE2-Vlanif10] mpls ldp
[PE2-Vlanif10] quit
# Configure PE3.
<PE3> system-view
[PE3] mpls lsr-id 3.3.3.3
[PE3] mpls
[PE3-mpls] label advertise non-null
[PE3-mpls] quit
[PE3] mpls ldp
[PE3-mpls-ldp] quit
[PE3] interface vlanif 30
[PE3-Vlanif30] mpls
[PE3-Vlanif30] mpls ldp
[PE3-Vlanif30] quit
Run the display mpls lsp command on the PEs, and you can see that LSPs are established
between PE1 and PE2 and between PE1 and PE3. Take PE1 for example.
[PE1] display mpls lsp
----------------------------------------------------------------------
LSP Information: LDP LSP
----------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/3 -/Vlanif30
1.1.1.1/32 3/NULL -/-
100.1.1.0/30 3/NULL -/-
3.3.3.3/32 1024/3 -/Vlanif30
100.2.1.0/30 3/NULL -/-
2.2.2.2/32 NULL/3 -/Vlanif10
2.2.2.2/32 1025/3 -/Vlanif10
Step 5 Configure VPN instances on each PE and connect the CEs to the PEs.
# Configure PE1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
# Configure PE2.
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-140 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)