Huawei Quidway S9300

After running the shutdown command in the view of VLANIF 40 on PE1 and the view of
VLANIF 50 on PE2, you can see that CE1 can ping CE2. This indicates that the RRs are
successfully configured.
Configuration Files
l Configuration file of PE1
#
sysname PE1
#
vlan batch 10 40 60
#
ip vpn-instance vpna
route-distinguisher 100:1
vpn-target 1:1 export-extcommunity
vpn-target 1:1 import-extcommunity
#
mpls lsr-id 1.1.1.9
mpls
lsp-trigger all
#
mpls ldp
#
interface Vlanif10
ip address 100.1.2.1 255.255.255.0
mpls
mpls ldp
#
interface Vlanif40
ip address 100.1.3.1 255.255.255.0
mpls
mpls ldp
#
interface Vlanif 60
ip binding vpn-instance vpna
ip address 10.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 60
port hybrid untagged vlan 60
#
interface GigabitEthernet3/0/0
port hybrid pvid vlan 40
port hybrid untagged vlan 40
#
interface LoopBack1
ip address 1.1.1.9 255.255.255.255
#
bgp 100
peer 2.2.2.9 as-number 100
peer 2.2.2.9 connect-interface LoopBack1
peer 3.3.3.9 as-number 100
peer 3.3.3.9 connect-interface LoopBack1
#
ipv4-family unicast
undo synchronization
peer 2.2.2.9 enable
peer 3.3.3.9 enable
#
ipv4-family vpnv4
policy vpn-target
peer 2.2.2.9 enable
peer 3.3.3.9 enable
#
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-152 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)