Huawei Quidway S9300

Run the display ip routing-table command on the CE, and you can see that CE1 and CE2 can
learn the interface routes of each other. CE1 and CE2 can ping each other.
Take CE1 for example.
<CE1> display ip routing-table
Route Flags: R - relied, D - download to fib
------------------------------------------------------------------------------
Routing Tables: Public
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost Flags NextHop Interface
100.1.1.0/24 Direct 0 0 D 100.1.1.1 vlanif10
100.1.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
100.1.1.2/32 Direct 0 0 D 100.1.1.2 Vlanif10
127.0.0.0/8 Direct 0 0 D 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
<CE1> ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=10 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=70 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=60 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 10/76/180 ms
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
#
interface Vlanif 10
ip address 100.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
return
l Configuration file of PE
#
sysname PE
#
vlan batch 10 20
#
mpls lsr-id 1.1.1.9
mpls
#
mpls l2vpn
#
interface Vlanif10
#
interface Vlanif20
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid tagged vlan 10
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-39