Huawei Quidway S9300

Reply from 10.1.3.1: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 10.1.3.1: bytes=56 Sequence=2 ttl=255 time=150 ms
Reply from 10.1.3.1: bytes=56 Sequence=3 ttl=255 time=150 ms
Reply from 10.1.3.1: bytes=56 Sequence=4 ttl=255 time=190 ms
Reply from 10.1.3.1: bytes=56 Sequence=5 ttl=255 time=160 ms
--- 10.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 150/166/190 ms
Step 9 Verify the configuration.
Run the display mpls l2vc interface command on PE1. If the configuration is successful, you
can see that the master PW is in Active state, the backup PW is in InActive state.
<PE1> display mpls l2vc interface vlanif 10
*client interface : Vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 3.3.3.3
local group ID : 0 remote group ID : 0
local VC label : 21504 remote VC label : 21504
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : cw lsp-ping bfd
remote VCCV : cw lsp-ping bfd
local control word : enable remote control word : enable
tunnel policy : p1
traffic behavior : --
PW template name : 1to3
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : cr lsp, TNL ID : 0x10002
create time : 0 days, 1 hours, 5 minutes, 19 seconds
up time : 0 days, 0 hours, 43 minutes, 33 seconds
last change time : 0 days, 0 hours, 43 minutes, 33 seconds
*client interface : Vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 200
VC type : VLAN
destination : 2.2.2.2
local group ID : 0 remote group ID : 0
local VC label : 21505 remote VC label : 21505
local AC OAM state : up
local PSN state : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : inactive
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-96 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)