Huawei Quidway S9300

[PE3-Tunnel2/0/0] mpls te tunnel-id 31
[PE3-Tunnel2/0/0] mpls te bandwidth bc0 20
[PE3-Tunnel2/0/0] mpls te commit
[PE3-Tunnel2/0/0] quit
[PE3] ospf 1
[PE3-ospf-1] opaque-capability enable
[PE3-ospf-1] area 0
[PE3-ospf-1-area-0.0.0.0] mpls-te enable
# Use MPLS LDP to establish LSPs.
# Configure PE1.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface vlanif 40
[PE1-Vlanif40] mpls ldp
[PE1-Vlanif40] quit
# Configure PE2.
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface vlanif 40
[PE2-Vlanif40] mpls ldp
[PE2-Vlanif40] quit
After the configuration, run the display tunnel-info all command on PEs. You can see that an
MPLS TE tunnel is set up between PE1 and PE3, and an MPLS LSP is set up between PE1 and
PE2.
Take the display on PE1 for example.
<PE1> display tunnel-info all
* -> Allocated VC Token
Tunnel ID Type Destination Token
----------------------------------------------------------------------
0x1003d cr lsp 3.3.3.3 0
0x10027 lsp -- 1
0x10028 sp 2.2.2.2 2
Step 6 Establish BGP L2VPN connections between PE1 and PE2, and between PE1 and PE3.
# Configure PE1.
[PE1] bgp 100
[PE1-bgp] peer 2.2.2.2 as-number 100
[PE1-bgp] peer 2.2.2.2 connect-interface loopback1
[PE1-bgp] peer 3.3.3.3 as-number 100
[PE1-bgp] peer 3.3.3.3 connect-interface loopback1
[PE1-bgp] l2vpn-family
[PE1-bgp-af-l2vpn] peer 3.3.3.3 enable
[PE1-bgp-af-l2vpn] peer 2.2.2.2 enable
# Configure PE3.
[PE3] bgp 100
[PE3-bgp] peer 1.1.1.1 as-number 100
[PE3-bgp] peer 1.1.1.1 connect-interface loopback1
[PE3-bgp] l2vpn-family
[PE3-bgp-af-l2vpn] peer 1.1.1.1 enable
# Configure PE2.
[PE2] bgp 100
[PE2-bgp] peer 1.1.1.1 as-number 100
[PE2-bgp] peer 1.1.1.1 connect-interface loopback1
[PE2-bgp] l2vpn-family
[PE2-bgp-af-l2vpn] peer 1.1.1.1 enable
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-109