AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: cr lsp, id: 0x1003d
conn-type: remote
local vc state: up
remote vc state: up
local ce-id: 1
local ce name: ce1
remote ce-id: 3
intf(state,encap): Vlanif10(up,vlan)
peer id: 2.2.2.2
route-distinguisher: 100:3
local vc label: 25603
remote vc label: 25601
tunnel policy: default
primary or secondary: secondary
forward entry exist or not: true
forward entry active or not:false
manual fault set or not: not set
AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: lsp , id: 0x10028
Reroute policy : delay 30 s, resume 0 s
Reason of last reroute : --
Time of last reroute : -- days, -- hours, -- minutes, -- seconds
delay timer ID : -- rest time :--
resume timer ID : -- rest time :--
Remove the fault manually set on VLANIF 30 of PE3.
[PE3] interface vlanif 30
[PE3-Vlanif30] shutdown
The status of the primary VC becomes Down. The forwarding state of the master PW becomes
False, and that of the backup PW becomes True. Take the display on PE1 for example.
<PE1> display mpls l2vpn connection interface vlanif 10
conn-type: remote
local vc state: up
remote vc state: down
local ce-id: 1
local ce name: ce1
remote ce-id: 2
intf(state,encap): Vlanif10(up,vlan)
peer id: 3.3.3.3
route-distinguisher: 100:2
local vc label: 25602
remote vc label: 25601
tunnel policy: p1
primary or secondary: primary
forwardEntry exist or not: false
forward entry active or not:false
manual fault set or not: not set
AC OAM state: up
BFD for PW session index: --
BFD for PW state: down
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: cr lsp, id: 0x1003d
conn-type: remote
local vc state: up
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-113