EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure the dynamic PW on the U-PE. Enable dynamic PW switching on the S-PE.
# Configure U-PE1.
[U-PE1] mpls l2vpn
[U-PE1-l2vpn] quit
[U-PE1] interface vlanif 10
[U-PE1-Vlanif10] mpls l2vc pw-template pwt 100
[U-PE1-Vlanif10] quit
# Configure S-PE.
[S-PE] mpls l2vpn
[S-PE-l2vpn] quit
[S-PE] mpls switch-l2vc 1.1.1.9 100 between 5.5.5.9 200 encapsulation vlan
# Configure U-PE2.
[U-PE2] mpls l2vpn
[U-PE2-l2vpn] quit
[U-PE2] interface vlanif 60
[U-PE2-Vlanif60] mpls l2vc pw-template pwt 200
[U-PE2-Vlanif60] quit
Step 7 Verify the configuration.
1. Display information about the PWE3 connection.
Display information about the L2VPN connection on U-PE and S-PE. You can see that an
L2VC is set up and the VC status is Up.
Take the display on U-PE1 for example.
<U-PE1> display mpls l2vc interface vlanif 10
*client interface : Vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 3.3.3.9
local group ID : 0 remote group ID : 0
local VC label : 21504 remote VC label : 21505
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : cw lsp-ping
remote VCCV : cw lsp-ping
local control word : enable remote control word : enable
tunnel policy name : --
traffic behavior name : --
PW template name : pwt
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x20020
create time : 0 days, 0 hours, 15 minutes, 3 seconds
up time : 0 days, 0 hours, 3 minutes, 15 seconds
last change time : 0 days, 0 hours, 3 minutes, 15 seconds
Display the status of the switching L2VC on S-PE.
<S-PE> display mpls switch-l2vc
Total Switch VC : 1, 1 up, 0 down
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-56 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals