Huawei Quidway S9300

# Run the display ip routing-table vpn-instance verbose command on the PEs, and you can
see the tunnels used by the VPN routes.
# Take the display on PE1 as an example:
[PE1] display ip routing-table vpn-instance VPNA 10.3.1.0 verbose
Routing Table : VPNA
Summary Count : 1
Destination: 10.3.1.0/30
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
NextHop: 2.2.2.2 Neighbour: 2.2.2.2
State: Active Adv GotQ Age: 00h00m08s
Tag: 0 Priority: 0
Label: 109568 QoSInfo: 0x0
RelayNextHop: 0.0.0.0 Interface: Tunnel1/0/2
Tunnel ID: 0x1003d
[PE1] display ip routing-table vpn-instance VPNB 10.4.1.0 verbose
Routing Table : VPNB
Summary Count : 2
Destination: 10.4.1.0/30
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
NextHop: 2.2.2.2 Neighbour: 2.2.2.2
State: Active Adv GotQ Age: 01h02m27s
Tag: 0 Priority: 0
Label: 107520 QoSInfo:0x0
RelayNextHop: 0.0.0.0 Interface: Tunnel1/0/1
Tunnel ID: 0x1001c
# The CEs in the same VPN can ping each other, and the CEs in different VPNs cannot ping
each other.
----End
Configuration Files
l Configuration file of PE1
#
sysname PE1
#
vlan batch 10 20 30
#
ip vpn-instance VPNA
route-distinguisher 100:1
tnl-policy policy1
vpn-target 111:1 export-extcommunity
vpn-target 111:1 import-extcommunity
#
ip vpn-instance VPNB
route-distinguisher 100:2
tnl-policy policy2
vpn-target 222:2 export-extcommunity
vpn-target 222:2 import-extcommunity
#
mpls lsr-id 1.1.1.1
mpls
mpls te
label advertise non-null
mpls rsvp-te
mpls te cspf
#
mpls ldp
#
interface Vlanif10
ip address 100.1.1.1 255.255.255.252
mpls
1 VPN Tunnel Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
1-34 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)