Huawei Quidway S9300

# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 40
[CE2-Vlanif40] ip address 10.1.1.2 255.255.255.0
Step 9 Verify the configuration.
After the preceding configurations, run the display vsi name bgp1 verbose command on PE1.
You can find that a VSI named bgp1 sets up a PW to PE2, and the status of the VSI is UP.
.
<PE1> display vsi name bgp1 verbose
***VSI Name : bgp1
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : bgp
Member Discovery Style : auto
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
BGP RD : 168.1.1.1:1
SiteID/Range/Offset : 1/5/0
Import vpn target : 100:1,
Export vpn target : 100:1,
Remote Label Block : 25600/5/0,
Local Label Block : 25600/5/0,
Interface Name : Vlanif10
State : up
**PW Information:
*Peer Ip Address : 3.3.3.9
PW State : up
Local VC Label : 25602
Remote VC Label : 25601
PW Type : label
Tunnel ID : 0x20021,
CE1 (10.1.1.1) can ping CE2 (10.1.1.2) successfully.
<CE1> ping 10.1.1.2
PING 10.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 10.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-47