Huawei Quidway S9300

<PE> system-view
[PE] mpls l2vpn
[PE] vsi v123 static
[PE-vsi-v123] pwsignal ldp
[PE-vsi-v123-ldp] vsi-id 123
[PE-vsi-v123-ldp] peer 2.2.2.9
Step 5 Bind VSIs to interfaces on the SPE and UPE.
# Configure the UPE.
[UPE] interface vlanif 10
[UPE-Vlanif10] l2 binding vsi v123
[UPE-Vlanif10] quit
[UPE] interface vlanif 20
[UPE-Vlanif20] l2 binding vsi v123
[UPE-Vlanif20] quit
# Configure the PE.
[PE] interface vlanif 50
[PE-Vlanif50] l2 binding vsi v123
Step 6 Assign an IP address to each VLANIF interface on CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface Vlanif10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 20
[CE2-Vlanif40] ip address 10.1.1.2 255.255.255.0
# Configure CE3.
<Quidway> sysname CE3
[CE3] interface vlanif 50
[CE23-Vlanif50] ip address 10.1.1.3 255.255.255.0
Step 7 Verify the configuration.
After the preceding configurations, run the display vsi name v123 verbose command on the
SPE. You can view that the VSI named v123 is in the Up state and the corresponding PW is also
in the Up state.
<SPE> display vsi name v123 verbose
***VSI Name : v123
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
VSI ID : 123
*Peer Router ID : 3.3.3.9
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-53