EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
# Configure ASBR-PE2.
[ASBR-PE2] vsi a1 static
[ASBR-PE2-vsi-a1] pwsignal ldp
[ASBR-PE2-vsi-a1-ldp] vsi-id 3
[ASBR-PE2-vsi-a1-ldp] peer 4.4.4.4
[ASBR-PE2-vsi-a1-ldp] quit
[ASBR-PE2-vsi-a1] quit
[ASBR-PE2] interface vlanif 30
[ASBR-PE2-Vlanif30] l2 binding vsi a1
[ASBR-PE2-Vlanif30] quit
# Configure PE2.
[PE2] vsi a1 static
[PE2-vsi-a1] pwsignal ldp
[PE2-vsi-a1-ldp] vsi-id 3
[PE2-vsi-a1-ldp] peer 3.3.3.3
[PE2-vsi-a1-ldp] quit
[PE2-vsi-a1] quit
[PE2] interface vlanif 50
[PE2-Vlanif50] l2 binding vsi a1
[PE2-Vlanif50] quit
Step 6 Configure CEs.
# Configure CE1.
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 24
[CE1-Vlanif10] quit
# Configure CE2.
[CE2] interface vlanif 50
[CE2-Vlanif50] ip address 10.1.1.2 24
[CE2-Vlanif50] quit
Step 7 Verify the configuration.
After the preceding configurations, run the display vsi name verbose command on PE1. You
can find that a VSI named a1 sets up a PW to PE2, and the status of the VSI is UP.
.
<PE1> display vsi name a1 verbose
***VSI Name : a1
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
VSI ID : 2
*Peer Router ID : 2.2.2.2
VC Label : 23552
Peer Type : dynamic
Session : up
Tunnel ID : 0x20020,
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-71

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals