Navigation Function/submenu
5.4 Compressor start ■ Compressor ON
■ Compressor OFF
Auto start
Cut-in lock
Start temperature
5.5 Acknowledgement Remote operation
«Remote control» key
Acknowledging the remote contact
5.6 ADT ■ AIR 1.00
Conduit correction
■ Rate of rise of the airend discharge temper‐
ature
5.7 I/O periphery ■ DO functions
■ Analog values
■ External messages
■ Switch
For details of the
<I/O periphery>
menu, see ta‐
ble 32 “I/O periphery menu”.
5.8 Timer ■ ON
■ OFF
■ DOR 1.03
5.9 Refrigeration dryer ■ Control mode
─ Compressor standby
─ Compressor clock/FK/FB off
■ Temperature high
■ Temperature low
■ Activate fault mode
Tab. 30 Configuration menu
Pressure control menu
Navigation Function/submenu
5.2.1 Pressure sensors ■ System pressure pNloc
■ Internal pressure pi
5.2.2 Pressure settings ■ pRV Safety relief valve opening pressure
■ Pressure increase
■ Nominal pressure
■ System setpoint pressure
■ System pressure low
■ Minimum cut-in pressure
4 Design and Function
4.6 Menus – overview
24
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3 9_9450 03USE
To Next Page