Navigation Function/submenu
5.2.3 Load control ■ Set local mode
■ Set remote operation
Activate/deactivate «Remote control» key
■ Timer operating mode pA/pB
■ Remote contact operating mode pA/pB
■ Assign load mode remote contact
■ Assign local load remote contact:
■ Activate/deactivate the IDLE key
5.2.4 Network actual pressure Actual system pressure (pNloc)
AII
Tab. 31 Pressure control menu
I/O periphery menu
Navigation Function/submenu
5.7.1 DO functions Controller on
ON
Motor running
IDLE
LOAD
Group fault
Group warning
Remote operation
Timer active
EMERGENCY-OFF
■ Timer contact (enter timing program)
5.7.2 Analogue values Configure display of measured values
■ Display 1 (p)
■ Display 2 (p)
■ Display 3 (T)
■ Display 4 (T)
■ Display 5 (I)
■ Display 6 (I)
5.7.3 External messages Configure display of external messages
■ External message 1
■ External message 2
■ External message 3
■ External message 4
■ External message 5
■ External message 6
4 Design and Function
4.6 Menus – overview
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
25
To Next Page
Loading...
