Repair information 4-187
7462
Anti-tip latch assembly removal
The left and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below
are for removing the left latch, but removing the right latch is similar.
1. Remove the 550-sheet media tray assembly. See “550-sheet media tray assembly removal” on
page 4-184.
2. Turn the drawer over so that you are looking at the bottom of the anti-tip assembly. Using a flathead
screwdriver, unsnap the two hooks (A) securing the anti-tip latch to the drawer.
Note: The hooks might break when detaching the anti-tip latch assembly from the drawer.
3. Remove the anti-tip latch assembly.
To Next Page
Loading...
Need help?
General
