LSIS XGT Series - Page 338

Chapter 6 Motion Function Blocks
6-199
(5) The group number and the number in the group of each parameter are as follows.
Parameters
Group
No.
Item
Description
1. Channel
parameters
1. Basic
setting
1 Target machining quantity Set the target machining quantity.
(0 ~ 2,147,483,647)
2 Target machining quantity
at M99 repeated
machining
Set the target machining quantity for repeated
machining with M99. If the set value matches the
current machining quantity, the cycle automatically
stops.
(0 ~ 2,147,483,647)
3 Check of decimal point Set whether to check decimal point of the NC
program.
0: Decimal point check
(Mm if there is a decimal point, um if there is no
decimal point)
1: No decimal point check (mm)
4
Keep workpiece
coordinate system
Set whether to keep the workpiece coordinate
system when resetting.
0: Keep
1: Do not keep
5 Whether to call the macro
when the T code is
commanded
Set whether to call the macro program (9000.nc ~
9009.nc) when the T code is commanded.
0: Do not call
1: Call
6 Dwell Method Set the dwell function (G04) to use the data
corresponding to X, P as time or the number of
revolutions of the spindle.
If the data is set to the number of revolutions of the
spindle, it is applied in the status of feed per
revolution (G95).
0: Time
1: Number of revolutions
7 Select a progress block at
reset
Set whether to initialize to the start block of the
program at reset.
※ If you want to set to 0 (keep the current block), the
parameters of "Keep workpiece coordinate system"
should be set to 0 (keep).
0: Keep the current block
1: Initialize to the start block of the main program
2: Initialize to the current block of the main program