Chapter 6 Motion Function Blocks
parameters
setting
the Statement Number
The number of buffers that can store the program’s
Statement Number (N__) is limited to 1,000 in the
system.
This buffer is needed if the program changes the
sequence using a GOTO statement.
If more than 1,000 blocks have the N__ command,
an alarm will occur.
This parameter is used to input whether or not to
execute such Statement Number search.
Because high- capacity CAM programs do not have
GOTO using the Statement Number and in the
majority of cases, there are more than 1,000
Statement Numbers, you should set this parameter
as 1.
0: Search
12 Minimum command unit When decimal point check is applied, set the
minimum unit of the commanded value.
18 Whether to use G22 No
0: ‘No Travelling Area’ is valid.
1: ‘No Travelling Area’ is invalid.
Set the inner/outer side of
G22 No Travelling Area
0: Inner side
1: Outer side
Whether to use the 3rd ‘No
Travelling Area’
0: ‘No Travelling Area’ is valid.
1: ‘No Travelling Area’ is invalid.
Rotary axis of Cylindrical
interpolation
In the cylindrical interpolation mode, the axis maps
the axis of rotation during the circular
interpolation.The axes are X, Y, Z and perform the
circular interpolation by mapping the axis of rotation
to the selected axis.
For example, if the axis of rotation is mapped to the X
axis under the state of the XY plane (G17), the width
becomes the axis of rotation and the height becomes
Y axis. When ZX (G18) is selected as the plane, the
width becomes the Z axis and the height becomes
the axis of rotation. However, if you set the plane to
YZ (G19), you cannot perform the circular
interpolation on the commanded axis of rotation.
0: X-axis,
1: Y-axis,
Linear axis for interpolating
the polar coordinate
0: Unused
1: X, 2: Y, 3: Z, 4: A, 5: B, 6: C, 7: U, 8: V, 9: W
24 Rotary axis for
interpolating the polar
0: Unused
1: X, 2: Y, 3: Z, 4: A, 5: B, 6: C, 7: U, 8: V, 9: W
To Next Page
Loading...
