Chapter 9 NC Control Function
The parameters related to Enable /Disable stroke are as follows.
Group name and parameter name
10) Homing check (G27)
(G90, G91) G27 X_ Y_ Z_ A_ B_ C_ U_ V_ W_ S_
G90, G91: Absolute/Incremental command
G27: Homing check
X_ Y_ Z_ A_ B_ C_ U_ V_ W_ S_: Target coordinates
Through this command, it traverses to the specified X, Y, Z coordinate. When the current position is the origin
after the traverse is done, homing is completed. If it is not the origin, the alarm occurs. When this command is
instructed, the compensations of tool diameter and tool length are canceled.
To Next Page
Loading...
