Chapter 9 NC Control Function
If the positioning direction is specified for the X + direction as shown in the figure, it will always move from the same
direction to the target position.
If the overrun amount is not set or the feed amount is 0, the single direction positioning command is not applied.
In addition, it does not apply to the Z axis in the drill cycle, and it is not affected by the mirror image for the set
direction.
G21
G17 G40 G80 T01
M06
G90 G54 G60 X5.0 Y5.0
S1200 M03 T02
G43 Z2.5 H01 M08
G99 G82 R2.5 Z-2.0 P200
F150.0
G60 Y20.0
G60 X20.0
G60 Y5.0
G80 Z2.5 M09
G28 Z2.5 M05
M01
To Next Page
Loading...
