LSIS XGT Series - Page 572

Chapter 9 NC Control Function
9-69
Parameters
Group
No.
Item
Description
1. Channel
parameters
10.
Workpiece
coordinate
system
79
G57 workpiece coordinate
system value 9
Set the G57 workpiece coordinate system values
for the W axis.
81
G58 workpiece coordinate
system value 1
Set the G58 workpiece coordinate system values
for the X axis.
……
……
Set the G58 workpiece coordinate system values
for the 7 axes; Y, Z, A, B, C, U, V
89
G58 workpiece coordinate
system value 9
Set the G58 workpiece coordinate system values
for the W axis.
91
G59 workpiece coordinate
system value 1
Set the G59 workpiece coordinate system values
for the X axis.
……
……
Set the G59 workpiece coordinate system values
for the 7 axes; Y, Z, A, B, C, U, V
99
G59 workpiece coordinate
system value 9
Set the G59 workpiece coordinate system values
for the W axis.
11. Macro
program
1
Whether to apply the single
block stop function to the
macro program
Set whether to apply the single block stop function
to the macro program(9000.nc ~ 9999.nc)
0: Stop
1: Do not stop
2
Display the macro program
block
Set whether to display the progress status of the
block on the screen when operating the macro
program (9000.nc ~ 9999.nc).
0: Do not display
1: Display
9
T code call Macro program
number
Enter the number of the macro program (9000.nc
~ 9009.nc) to be called when the T code is
commanded.
(9000 ~ 9009, integer)
10
Macro program call G code
(9010.nc)
Set the G code number to call the macro program
(9010.nc ~ 9019.nc) that can be called by the G
code.
※ The setting values 0, 1, 2, 3 are ignored.
(0~255.9, real number)
……
……