LSIS XGT Series - Page 574

Chapter 9 NC Control Function
9-71
Parameters
Group
No.
Item
Description
1. Channel
parameters
16. Relative
coordinate
setting
1
Relative coordinate‟s
offset value #1
Set the relative coordinate‟s offset value for the
X axis.
2
Relative coordinate‟s
offset value #2
Set the relative coordinate‟s offset value for the
Y axis.
3
Relative coordinate‟s
offset value #3
Set the relative coordinate‟s offset value for the
Z axis.
4
Relative coordinate‟s
offset value #4
Set the relative coordinate‟s offset value for the
A axis.
5
Relative coordinate‟s
offset value #5
Set the relative coordinate‟s offset value for the
B axis.
6
Relative coordinate‟s
offset value #6
Set the relative coordinate‟s offset value for the
C axis.
7
Relative coordinate‟s
offset value #7
Set the relative coordinate‟s offset value for the
U axis.
8
Relative coordinate‟s
offset value #8
Set the relative coordinate‟s offset value for the
V axis.
9
Relative coordinate‟s
offset value #9
Set the relative coordinate‟s offset value for the
W axis.
2.Channel/Axis
parameters
1. Axis
setting
2
Setting the direction for
the modular axis
Set the traverse command for the axis set as
the modular axis.
0: Unidirectional
1: Bidirectional
2. Origin
1
Coordinates of the 2nd
origin
Set the coordinates of the 2nd origin.
2
Coordinates of the 3rd
origin
Set the coordinates of the 3rd origin.
3
Coordinates of the 4th
origin
Set the coordinates of the 4th origin.
3. Rapid
traverse
2
Rapid traverse
acceleration
The set value is used as the acceleration of the
G00 block.
3
Rapid traverse
deceleration
The set value is used as the deceleration of the
G00 block.
4
Rapid traverse jerk
The set value is used as the jerk of the G00
block.