Chapter 12 SD Additional Function
In the comparison mode with the PLC, the description of each item is as follows.
Select the storage medium to store the project data
Location where you will save the project data (folder)
Select operation mode
Set the PLC operations when inserting the SD card
Comparison with the PLC: Compare the projects stored in the PLC and
Only the desired items can be compared.
Save comparison results to a
Check whether the comparison result is saved as csv type file.
(4) PLC boot operation
It is the function to start the PLC by using the project stored in the SD. If you turn Off, On the PLC after removing
the SD, it runs by the program that was driven before boot operation.
The description of each item in the PLC boot operation mode is as follows.
Select the storage medium to store the project data
Location where you will save the project data (folder)
Select operation mode
Set the PLC operations when inserting the SD card
PLC boot operation: Operating the PLC using the data stored in the SD
Check whether the PLC boot operation can be updated using the SD
Specify the PLC that can execute the PLC boot operation
To Next Page
Loading...
