215184 180 Revision A
Figure 6.11: Ultra Wide Configuration – Rear View
Ultra Wide configuration is an optional configuration for the
following combines:
• CLAAS 590R/595R, 660/670, 760/770/780/7000/8000
The Ultra Wide configuration uses no bolt on flighting; only the
factory-welded flighting (A) is responsible for conveying
the crop.
NOTE:
This configuration may improve feeding for wide feeder house
combines.
A total of 30 auger fingers are recommended for this
configuration.
To convert to Ultra Wide configuration from Medium configuration, refer to 6.2.5 Converting from Medium Configuration
to Wide Configuration or Ultra Wide Configuration, page 188.
To convert to Ultra Wide configuration from Ultra Narrow or Narrow configuration, refer to 6.2.6 Converting from Ultra
Narrow or Narrow Configuration to Wide or Ultra Wide Configuration, page 190.
To convert to Ultra Wide configuration from Wide configuration, refer to 6.2.7 Converting from Wide Configuration to
Ultra Wide Configuration, page 192.
FLOAT MODULE SETUP AT DEALER
To Next Page
Loading...
