215184 215 Revision A
Figure 7.24: Connecting Driveline to Combine
7. Pull back collar (A) on end of driveline and push onto
combine output shaft (B) until collar locks.
Figure 7.25: Multicoupler Receptacles
8. Lower handle (A) to release multicoupler (B) from header.
9. Open cover (C) on the combine receptacle.
10. Push handle (D) to fully open position.
11. Clean mating surfaces of coupler and receptacle if
necessary.
Figure 7.26: Multicoupler
12. Position coupler (A) onto combine receptacle, and pull
handle (B) to fully engage multicoupler into receptacle.
ATTACHING HEADER TO COMBINE
To Next Page
Loading...
