215184 269 Revision A
Figure 8.17: Reel Endshield and Header Endsheet
NOTE:
The picture to the right shows reel endshield (A) and header
endsheet (B). Measure the clearance between reel endshield (A)
and header endsheet (B) at both ends of the header. The
clearances should be the same if the reel is centered.
Figure 8.18: Center Support Arm and Braces – Double
Reel Only
4. Double Reel Only: If the reel is not centered, follow
these steps:
a. Loosen bolt (A) on each brace (B).
b. Move the forward end of center support arm (C)
laterally as required to center both reels.
c. Tighten bolts (A) and torque to 359 Nm (265 lbf·ft.).
PERFORMING PREDELIVERY CHECKS
To Next Page
Loading...
