215184 270 Revision A
Figure 8.19: Support Arm and Brace – Single Reel
Only, Right End Shown, Left End Opposite
5. Single Reel Only: If the reel is not centered, follow
these steps:
a. Loosen bolt (A) on brace (B) at both ends of the reel.
b. Move the forward end of reel support arm (C) laterally
as required to center the reel.
c. Tighten bolts (A), and torque to 359 Nm (265 lbf·ft.).
PERFORMING PREDELIVERY CHECKS
To Next Page
Loading...
