MacDon D1 Series - Page 373

215184 349 Revision A
1003939
Figure 9.97: Case IH Combine Display
8. Install REEL FORE-BACK to YES (if applicable).
1025380
A
B
Figure 9.98: Case IH Combine Display
9. Locate HHC HEIGHT SENSITIVITY field (A), and set as
follows:
• If using a two-sensor system: Set HHC HEIGHT
SENSITIVITY to 250.
• If using a single-sensor system: Set HHC HEIGHT
SENSITIVITY to 180.
NOTE:
If hunting occurs during operation, decrease this setting by
20 points at a time until hunting no longer occurs.
10. Set HHC TILT SENSITIVITY (B) to 150. Increase or decrease
as desired.
1003940
Figure 9.99: Case IH Combine Display
11. Install FORE/AFT CONTROL and HDR FORE/AFT TILT (if
applicable).
SETTING UP AUTO HEADER HEIGHT CONTROL