215184 354 Revision A
Figure 9.111: Case IH Combine Display
18. Select CALIBRATION on the combine display, and press the
right arrow navigation key to enter the information box.
19. Select HEADER (A), and press ENTER. The CALIBRATION
dialog box opens.
NOTE:
You can use the up and down navigation keys to move
between options.
Figure 9.112: Case IH Combine Display
20. Follow the calibration steps in the order in which they
appear in the dialog box. As you proceed through the
calibration process, the display will automatically update to
show the next step.
NOTE:
Pressing the ESC key during any of the steps or letting the
system sit idle for more than 3 minutes will cause the
calibration procedure to stop.
NOTE:
Refer to your combine operator’s manual for an
explanation of any error codes.
21. When all steps have been completed, CALIBRATION SUCCESSFUL message is displayed on the page. Exit the
CALIBRATION menu by pressing the ENTER or ESC key.
NOTE:
If float was set heavier to complete the AHHC calibration procedure, adjust to recommended operating float after the
calibration is complete.
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
