MacDon D1 Series - Page 400

215184 376 Revision A
1003689
A
B
Figure 9.159: CLAAS Combine Display, Console, and
Control Handle
6. Use control knob (A) to highlight the icon that resembles a
screwdriver (B).
7. Engage the combine separator and feeder house.
8. Press control knob (A) and a progress bar will appear.
1003690
A
Figure 9.160: CLAAS Combine Display, Console, and
Control Handle
9. Fully raise the feeder house. Progress bar (A) will advance
to 25%.
10. Fully lower the feeder house. Progress bar (A) will advance
to 50%.
11. Fully raise the feeder house. Progress bar (A) will advance
to 75%.
12. Fully lower the feeder house. Progress bar (A) will advance
to 100%.
1003691
A
Figure 9.161: CLAAS Combine Display, Console, and
Control Handle
13. Ensure progress bar (A) displays 100%. The calibration
procedure is now complete.
NOTE:
If the voltage is not within the range of 0.5–4.5 V at any
time throughout the calibration process, the monitor will
indicate learning procedure not concluded.
NOTE:
If float was set heavier to complete ground calibration
procedure, adjust to recommended operating float after
the calibration is complete.
SETTING UP AUTO HEADER HEIGHT CONTROL