215184 461 Revision A
Figure 9.350: John Deere S7 Display – Header
Calibration
10. Select START on calibration overview page.
11. Follow instructions that appear on combine display. As you
proceed through calibration process, display will
automatically update to show next step.
NOTE:
If an error code appears during calibration, sensor is out of
voltage range and will require adjustment. For instructions,
refer to Adjusting Voltage Limits – One-Sensor System, page
314.
Figure 9.351: John Deere S7 Display – Header
Calibration
12. When calibration is complete, select SAVE to confirm
calibration.
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
