Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Chapter 11 168
To create a sequential data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see “Creating a Data File” on page 163 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-5 on page 168):
a) Enter the START ID and END ID values.
b) Select CREATE.
Figure 11‑5 Selecting the ID range for the sequential file type
11.2.1.3 Sequential with Custom Points Data File Type
The sequential with custom point (SEQ+CUSTOM PT) data file type is defined by a
starting and an ending ID number plus a series of custom points. The resulting file is
inclusive of the start and end points and all points in between. In addition, multiple
thickness readings per ID number location are assigned using the assigned custom
points.
Use the sequential with custom point data file type for example when you want to
measure along a pipe or tube, where at each ID number location, you can take
measurements at the top, bottom, left, and right of the pipe (see an example in
Table 14 on page 169).

Olympus 38DL PLUS Specifications

General

Operating Temperature	-10 °C to 50 °C (14 °F to 122 °F)
Data Logger	Yes
Interface	USB, RS-232
Thickness Range	0.08 mm to 635 mm (0.003 in. to 25 in.) depending on material and transducer
Display	Backlit LCD
Battery Type	Three alkaline or NiMH AA cells
Pulser	Adjustable square wave pulser
Receiver Bandwidth	0.5 MHz to 20 MHz
Languages	English, French, German, Spanish, Italian, Russian, Japanese, Chinese
Resolution	0.001 mm or 0.0001 in.
Transducer Frequency	2 MHz to 30 MHz
Material	Plastic housing