DMTA-10004-01EN, Rev. D, November 2016
Chapter 11
180
Figure 11‑13 Configuring the ID range for a boiler data file type
11.2.1.8 3-D Custom File Type
The 3-D custom file type is very similar to a standard 3-D Grid except that the point
parameter can be a custom list of points.
Table 18 on page 180 shows an example where the custom point increments first, the
custom row second, and the column third.
To create a 3-D custom data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see “Creating a Data File” on page 163 for details on the first parameters).
Table 18 Resulting ID example for the 3‑D CUSTOM file type
Parameters Va lu e
CUSTOM
ROWS
CUSTOM
POINTS
Resulting IDs
START COLUMN
END COLUMN
A
F
-TOP-
-MIDDLE-
-BOTTOM-
LEFT
RIGHT
A-TOP-LEFT
A-TOP-RIGHT
A-MIDDLE-LEFT
A-MIDDLE-RIGHT
...
F-BOTTOM-LEFT
F-BOTTOM-RIGHT
To Next Page
Loading...
