DMTA-10004-01EN, Rev. D, November 2016
Chapter 11
198
Figure 11‑27 Identifying the ID review screen
The ID review screen has three purposes:
• Review datalogger contents by scanning through stored ID locations in the active
file.
• Move within the data file and change the current ID location to any location that
already exists in the data file.
Gain when using a
dual element
transducers
Probe type:
Dual element:
DE-STD: Standard
DE-AEtoE: Automatic echo-to-echo
DE-MEtoE: Manual echo-to-echo
DE-EMAT: EMAT
Single element:
SE-M1: Mode 1
SE-M2: Mode 2
SE-M3: Mode 3
ID review mode:
m: Min Active
m: MIN: Held minimum
M: Max Active
M: MAX: Held maximum
m/M: Min/Max Active
m/M: BOTH: Held Min/Max
Stored value:
Differential mode:
D:X.XXXIN: Normal
D: XX.X%: Percentage
Alarm:
A: Alarm on
A: LOW: Low alarm
A: HIGH: High Alarm
Absolute previous alarm mode:
A: LOSS: Loss Alarm
A: GROWTH: Growth Alarm
Percent previous alarm mode:
A:%LOSS: % Loss Alarm
A:%GROWTH: % Growth Alarm
Active ID
To Next Page
Loading...
