Olympus 38DL PLUS - Figure 11-14 Configuring the ID Range for a 3-D Custom Data File Type

DMTA-10004-01EN, Rev. D, November 2016
Using the Datalogger 181
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-14 on page 181):
a) Enter the START COLUMN, and END COLUMN values.
b) Enter two or more CUSTOM ROWS values.
c) Press [2nd F], [] to finish entering CUSTOM ROWS values.
d) Enter two or more CUSTOM POINTS values.
e) Press [2nd F], [] to finish entering CUSTOM POINTS values.
f) In INC 1ST BY, select which parameter increments first (POINT, ROW, or
COLUMN).
g) In INC 2ND BY, select which parameter increments second (POINT, ROW, or
COLUMN).
h) Select CREATE.
Figure 11‑14 Configuring the ID range for a 3‑D custom data file type
The columns of the 38DL PLUS can increment past Z. For example:
Start Column: A;
End Column: AC;
Column Result: A, B, C,...Z, AA, AB, AC.
NOTE