Olympus 38DL PLUS - Figure 11-28 Editing the ID # Edit Mode

DMTA-10004-01EN, Rev. D, November 2016
Chapter 11 200
To use the ID edit mode
1. Open the file in which you wish to edit an ID (see “Opening a File” on page 184).
2. From the measurement screen, press [ID#].
3. Select the ID you wish to edit (see “Reviewing Stored Data and Changing the
Active ID” on page 199).
4. Press [ID#] again, and edit the ID value (see Figure 11-28 on page 200).
Figure 11‑28 Editing the ID # edit mode
5. Press [MEAS] to return to the measurement screen with the new active ID.
6. When the edited ID is not in the database, the help text bar message shown in
Figure 11-29 on page 201 appears, select INSERT to insert the new ID before the
active ID.
OR
Select APPEND to add the new ID at the end of the file.