Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Initial Setup 49
4. Initial Setup
The following sections describe basic system configurations.
4.1 Setting the User Interface Language and Other System Options
You can configure the 38DL PLUS to present the user interface in the following
languages: English, German, French, Spanish, Japanese, Chinese, Russian, Swedish,
Italian, Norwegian, Portuguese, Czech, and a customized interface. You can also set
the character delimiting the radix of a number.
The 38DL PLUS includes a beep tone generator to confirm when a key is pressed and
to notify you of an alarm condition. You can set the beeper on or off.
To save battery while you do not use the instrument, you can enable the inactive time
function so that the instrument automatically turns off when no key has been pressed
and no measurement has been made within about six minutes.
To change the user interface language and other system options
1. Press [SETUP MENU].
2. In the menu, select SYSTEM.
3. In the SYSTEM screen (see Figure 4-1 on page 50):
a) Set BEEPER to ON or OFF.
b) Set INACTIVE TIME to ON or OFF.
c) Set LANGUAGE to the desired language.
d) Set RADIX TYPE to the desired character (period or comma) to separate the
integer and the decimal digits.

Olympus 38DL PLUS Specifications

General

Operating Temperature	-10 °C to 50 °C (14 °F to 122 °F)
Data Logger	Yes
Interface	USB, RS-232
Thickness Range	0.08 mm to 635 mm (0.003 in. to 25 in.) depending on material and transducer
Display	Backlit LCD
Battery Type	Three alkaline or NiMH AA cells
Pulser	Adjustable square wave pulser
Receiver Bandwidth	0.5 MHz to 20 MHz
Languages	English, French, German, Spanish, Italian, Russian, Japanese, Chinese
Resolution	0.001 mm or 0.0001 in.
Transducer Frequency	2 MHz to 30 MHz
Material	Plastic housing