Olympus 38DL PLUS - Table 15 Resulting ID Example for the 2 D+CUSTOM PT File Type

DMTA-10004-01EN, Rev. D, November 2016
Using the Datalogger 175
To create a 2-D grid with custom points data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see “Creating a Data File” on page 163 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-11 on page 176):
a) Enter the START COLUMN, END COLUMN, START ROW, and END ROW
values.
b) Enter two or more CUSTOM POINTS values.
c) Press [2nd F], [] to finish entering CUSTOM POINTS values.
d) In INC 1ST BY, select which parameter increments first (POINT, ROW, or
COLUMN).
e) In INC 2ND BY, select which parameter increments second (POINT, ROW, or
COLUMN).
f) Select CREATE.
Table 15 Resulting ID example for the 2D+CUSTOM PT file type
Parameters Va lu es
CUSTOM
POINTS
Resulting IDs
START COLUMN
END COLUMN
START ROW
END ROW
A
J
01
17
LEFT
CENTER
RIGHT
A01LEFT
A01CENTER
A01RIGHT
A02LEFT
...
J17RIGHT