Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Using the Datalogger 179
To create a boiler data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see “Creating a Data File” on page 163 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-13 on page 180):
a) Enter the START TUBE and END TUBE values.
b) Enter two or more CUSTOM POINTS values.
c) Press [2nd F], [] to finish entering CUSTOM POINTS values.
d) Enter two or more ELEVATIONS values.
e) Press [2nd F], [] to finish entering ELEVATIONS values.
f) In INC 1ST BY, select which parameter increments first (POINT, TUBE, or
ELEVATIONS).
g) In INC 2ND BY, select which parameter increments second (POINT, TUBE,
or ELEVATIONS).
h) Select CREATE.
Table 17 Resulting ID example for the BOILER file type
ELEVATIONS START TUBE END TUBE
CUSTOM
POINTS
Resulting IDs
10FT
20FT
45FT
100FT
01 73 L (left)
C (center)
R (right)
10FT-01L
10FT-01C
10FT-01R
10FT-02L
...
10FT-73R
20FT-01L
...
100FT-73R

Olympus 38DL PLUS Specifications

General

Operating Temperature	-10 °C to 50 °C (14 °F to 122 °F)
Data Logger	Yes
Interface	USB, RS-232
Thickness Range	0.08 mm to 635 mm (0.003 in. to 25 in.) depending on material and transducer
Display	Backlit LCD
Battery Type	Three alkaline or NiMH AA cells
Pulser	Adjustable square wave pulser
Receiver Bandwidth	0.5 MHz to 20 MHz
Languages	English, French, German, Spanish, Italian, Russian, Japanese, Chinese
Resolution	0.001 mm or 0.0001 in.
Transducer Frequency	2 MHz to 30 MHz
Material	Plastic housing