Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Chapter 5 86
• n: LOS in manual echo-to-echo detection mode
• L: LOS in standard echo detection mode
5.7 Using the VGA Output
You can connect the 38DL PLUS to an external screen or projector to more easily show
the content of the 38DL PLUS screen to other people. This feature is particularly
useful when you need to train other 38DL PLUS users.
When you activate the VGA output, the 38DL PLUS screen becomes blank and its
contents appears only on the connected external screen. The VGA output is always
turned off when you restart the 38DL PLUS.
To use the VGA output
1. Turn off the 38DL PLUS.
2. Connect the optional VGA output cable (P/N: EPLTC-C-VGA-6 [U8840035]) to the
VGA output connector, located under the I/O door on the right side of the
38DL PLUS (see Figure 1-5 on page 25).
3. Connect the other end of the VGA output cable to the external screen or projector.
4. Turn on the 38DL PLUS.
5. Turn on the external screen or projector.
6. Press [DISPLAY].
7. In the DISPLAY SETTINGS screen (see Figure 4-3 on page 52), set VGA
OUTPUT to ON.
The 38DL PLUS screen becomes blank and the 38DL PLUS screen contents
appears on the external screen.
8. Turn the instrument off and then back on if you need to restore the contents on
the 38DL PLUS screen.

Olympus 38DL PLUS Specifications

General

Operating Temperature	-10 °C to 50 °C (14 °F to 122 °F)
Data Logger	Yes
Interface	USB, RS-232
Thickness Range	0.08 mm to 635 mm (0.003 in. to 25 in.) depending on material and transducer
Display	Backlit LCD
Battery Type	Three alkaline or NiMH AA cells
Pulser	Adjustable square wave pulser
Receiver Bandwidth	0.5 MHz to 20 MHz
Languages	English, French, German, Spanish, Italian, Russian, Japanese, Chinese
Resolution	0.001 mm or 0.0001 in.
Transducer Frequency	2 MHz to 30 MHz
Material	Plastic housing