Orolia SecureSync 2400 - Page 476

xxxx 1GBE (Slot x) Edit Interface Settings: eth* Window
Add your network information in the following fields to edit or add network information to
an Ethernet port. (Some selections will reveal or hide additional fields).
General Status tab:
Enable Interface [checkbox]
Auto-connect [checkbox]
MTU (0=auto)
IPv4 Status tab
Enable DHCP [checkbox]
Address
Subnet Mask
Gateway
Ignore Auto DNS? [checkbox]
Ignore Auto Routes? [checkbox]
Primary DNS
Secondary DNS
IPv6 Status tab
Enable DHCP [checkbox]
Address
Subnet prefix
Gateway
Ignore Auto DNS? [checkbox]
Ignore Auto Routes? [checkbox]
Primary DNS
Secondary DNS
NTP
To configure NTP on this set of option cards, navigate to MANAGEMENT > NTP Setup.
In the Actions panel, select the Configure xxxx 1GBE (Slot x) button.
In the xxxx 1GBE (Slot x) NTP Status window are four tabs:
460 SecureSync 2400 User Manual
APPENDIX