Orolia SecureSync 2400 User Manual

Pin Number Signal Name Function
8 NC No connection
9 NC No connection
Viewing the State of Event Broadcast and Event Input
To view the Status of Event Broadcast and Event Input, see "Viewing an Input/Output Sig-
nal State" on page337.
Event Broadcast Output: Edit Window
To configure the Event Broadcast Output, go to its Edit window. For instructions, see:
"Configuring Option Card Inputs/Outputs" on page336.
The Web UI list entry for this card is: Event Broadcast.
The Edit window allows the configuration of the following settings:
Signature Control: Signature Control controls when messages will be broadcast in
response to events on the Event Input (J2) port when events are enabled and the
card is in “broadcast” mode. (Events are still queued even if they are not broadcast,
and are transmitted once the signature control conditions permit.) For more inform-
ation on Signature Control, see "Signature Control" on page161.
Format: Selects the format of the message to be outputted. Refer to "Event Broad-
cast Time Code Formats" on page511 for a description of all of the available
formats.
The Event Broadcast card only supports two formats (Event Broadcast Format 0
and Event Broadcast Format 1), and only supports the output of one message per
event. If format is set to “None”, no messages will be queued in the Message Buffer.
SecureSync 2400 User Manual 507
APPENDIX

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English