Plockmatic BM500 - REP 10.16 Upper Trim Knife

Plockmatic BM3050 system 27 August 2019 3. Repairs and adjustments (REP and ADJ)
3-78
Replacement Upper Knife
1. First tighten the screws (x6) [A] completely, and then loosen them
counter clockwise half a revolution.
[A]
REP 10.16 Upper Trim Knife
Parts List on PL 11.10
WARNING:
When removing the chain nothing holds upper knife beam and lower knife in position.
Extreme caution should be taken when working with knife removal or replacement.
Removal Upper Knife
1. Turn off the main power and disconnect the power cord.
2. Undock BM and SQF (REP 1.0 Undocking BM / TR / SQF) or
remove Stacker (REP 8.0 Stacker Module).
3. Remove Front and Rear Cover (REP 10.0 Front and Rear Cover).
4. Remove Infeed Cover (REP 10.2 Infeed cover).
5. Remove Fan assembly (REP 10.3 TR-M5 / M6 Blower Motor (Blower Assembly).
6. Remove Upper knife protection plate.
7. Assemble the transport protection plate by tighten the screws (x2) [A].
8. Remove the upper knife by removing the screws (x6) [B].
[A]
[B]