Plockmatic BM3050 system 27 August 2019 3. Repairs and adjustments (REP and ADJ)
3-83
Sensor
TR-Q7
[A]
Sensor TR-Q11
Replacement
1. When positioning the carriage in place, make sure the two sliding rods and the gear rack
enters their holes and slots.
2. Reverse removal procedure (BQ 21 Stop Gate Carriage).
REP 10.20 TR-M3 Stop Gate Motor,
TR-Q7 Stop Gate Home Position sensor &
TR-Q11 length adjustment home position sensor
Parts List on PL 11.9
Removal Motor
1. Remove Stop Gate Carriage (REP 10.19 Stop Gate Carriage).
2. Loosen the motor screws (x2) and turn the motor [A] and lift it out.
Replacement
1. Reverse the removal procedure.
2. Check adjustment according to (ADJ 10.21 TR-Q11 Length Adjustment Home Position
Sensor) and (BQ20).
11. Loosen screws (x2) [F] and (x4) [G].
12. Pull out the Stop Gate Carriage [G] gently so the motor connectors (x2)
will not be damaged.
CAUTION:
When removing the Carriage, watch out so the motor connectors (2)
do not get damaged by the side frame cut-outs.
[G]
Removal Sensors
1. Remove Stop Gate Carriage (REP 10.19 Stop Gate Carriage).
2. Remove sensors TR-Q7 and TR-Q11.
REP 10.19 Stop Gate Carriage, continued
To Next Page
Loading...
