Plockmatic BM500 User Manual

Plockmatic BM3050 system 27 August 2019 5. Service tables (GP)
5-26
GP 15 SQF Service Adjust stop gate (Square Folder Module)
Purpose
This procedure is used when performing BQ 12 Square Fold Stop Gate Adjustment A.
NOTE:
Adjust Mode should only be set to YES when
performing BQ 10 Square Fold Stop Gate Adjustment A.
Procedure
1. Enter Service Mode (GP 1).
2. Select target (module) SQF.
3. Select item “Adjust mode:NO”.
4. Press [Change] and conrm by pressing [Yes].
5. Press [Home] to reach Target selection menu.
6. Press [Exit service] when ready to exit service mode.
NOTE:
After adjustment, make sure to set adjust mode back to “Adjust mode: NO”.
GP 16 Counters
The counter function is currently not available for
Booklet maker, Square Folder and Trimmer.
Rotator Creaser Trimmer
1. Enter Service Mode (GP 1).
2. Select target (module) CST.
3. Select item “NVM”.
4. Select items “Rotated (Cnt)”, “Creased (Cnt)”, “Bleed Trimmed (Cnt)” and “Hardware
(Cnt)” to display readings.
5. Press [Go back] to return to CST Service Components.
6. Press [Home] to reach Target selection menu.
7. Press [Exit service] when ready to exit service mode.
Explanation:
Rotated (Cnt), Creased (Cnt) and Bleed Trimmed (Cnt) shows the actual numbers.
Hardware (Cnt) shows the number of sheets passed since the last thousand.
It counts up to 1000 and then resets to 0.
To get the actual hardware count, check the hardware counter in the CST.
Multiply by 1000 and add the number shown according to the procedure described above.

Plockmatic BM500 Specifications

General

Max Booklet Size	A4
Max Paper Weight	300 gsm
Min Paper Weight	60 gsm
Book Thickness	Up to 5 mm
Speed	500 booklets/hour
Maximum Number of Sheets	25 sheets
Maximum Number of Pages	100 pages
Stitching Positions	2