Plockmatic BM500 - REP 13.39 High Voltage Power Supply Unit (Optional, for Antistatic Bars)

Plockmatic BM3050 system 27 August 2019 3. Repairs and adjustments (REP and ADJ)
3-203
REP 13.39 High Voltage Power Supply Unit
(Optional, For Antistatic Bars)
Parts List on PL 12.50
CAUTION:
ESD Hazard! ESD (Electrostatic Discharge) can cause hardware crashes,
data and/or communications problems. Failure to use proper ESD procedures will cause damage to
electronic components (eg: PCBs). ESD problems can be minimized by maintaining all machine ground
connections, ensuring the proper handling of circuit boards/ sensors.
Use ESD protection when working near PCBs.
Failure to use ESD protection is likely to result in a PCB failure.
Removal
1. Turn off the main power and disconnect the power cord.
2. Undock the Booklet Maker (REP 1.0 Undocking BM / TR / SQF).
3. Remove the Exit Cover (REP 12.1 Infeed and Exit Cover).
4. Remove applicable component(s):
- Remove the High Voltage Power Supply Unit (Figure 1).
- Remove Antistatic Bars Exit (Figure 2).
- Remove Antistatic Bars Waste Transport (Figure 3).
- Remove component(s) from the High Voltage Power Supply Unit (Figure 4).
Continued on next page.
Removal High Voltage Power Supply Unit
1. Remove screws (x2) [A].
2. Disconnect antistatic bars (x4) [B].
3. Disconnect harness (x2) and slide out the High Voltage PSU [C].
Figure 1: Removal High Voltage Power Supply Unit
[A]
[B]
[C]