Plockmatic BM500 - Cables, Plugs and Jumpers; Basic Rules; Example of a Stand-Alone Booklet Maker

Plockmatic BM3050 system 27 August 2019 1. Installation Procedure
1-52
1.12.2 EXAMPLE OF A STAND-ALONE BOOKLET MAKER
1.12 CABLES, PLUGS AND JUMPERS
1.12.1 BASIC RULES
Termination Plugs must always be inserted at each end of the booklet
maker system, even on a stand-alone booklet maker.
The female plug is placed on the rst module in a system (e.g. the feeder).
Once you have connected the termination plugs correctly you cannot go
wrong.
Female Male
The communication cables have male
and female plugs.
They shall be connected from module to
module.
The Interlock Jumper must be installed on a Booklet
Maker without Square Fold or Trimmer connected.
The Square Fold and Trimmer modules are
powered from the booklet maker. The black
cables are used for this purpose.