Plockmatic BM500 - Exit Sensor CT-Q7 Not Activated in Time

Plockmatic BM3050 system 27 August 2019 4. Troubleshooting (RAP)
4-42
CT-210 Exit Sensor CT-Q7 Activated too long
At ”initialization” or during a run,
the Paper Exit Sensor CT-Q7 was blocked exceeding timeout.
Initial Actions
• Ensure that all connectors are properly connected.
• Ensure that the Paper Exit Sensor CT-Q7 (PL 12.46) is clean.
• Check that there are no obstructions in the paper path.
Procedure
Enter Service (GP 1).
Check Paper Exit Sensor Q7 according to GP4.
Exit Sensor (Q7) works OK.
Y N
Go to Paper Exit Sensor (Q7) RAP.
Check drive motor M1 according to GP4.
Drive Motor (M1) works OK.
Y N
Go to Drive Motor (M1) RAP.
Go to Drive Motor (M1) RAP and
check that transportation drive and idler rollers are in good working order.
Drive and Idler Rollers are OK.
Y N
Fix problem.
Check creaser motor M6 according to GP4.
Creaser Motor (M6) works OK.
Y N
Go to Creaser Motor (M6) RAP.
Ensure that the CST is correctly installed.
CheckrstforpaperpathmisalignmentandInterfaceCable.
Installation is OK.
N
Re-install CST
CT-209 Exit Sensor CT-Q7 Not activated in time
The Paper Exit Sensor CT-Q7 was not blocked within timeout.
Initial Actions
• Ensure that all connectors are properly connected.
• Ensure that the Paper Exit Sensor CT-Q7 (PL 12.46) is clean.
• Check that there are no obstructions in the paper path.
Procedure
Enter Service (GP 1).
Check Paper Exit Sensor Q7 according to GP4.
Exit Sensor (Q7) works OK.
Y N
Go to Paper Exit Sensor (Q7) RAP.
Check drive motor M1 according to GP4.
Drive Motor (M1) works OK.
Y N
Go to Drive Motor (M1) RAP.
Go to Drive Motor (M1) RAP and
check that transportation drive and idler rollers are in good working order.
Drive and Idler Rollers are OK.
Y N
Fix problem.
Check creaser motor M6 according to GP4.
Creaser Motor (M6) works OK.
N
Go to Creaser Motor (M6) RAP.